SparkFun-USB-Host-Shield.jpg

SparkFun USB Host Shield

Model No: ARD-00005

TK. 2450.47

TK. 2156.41

Availability: In stock

Quantity:

Category: Arduino & Accessories

Supplier: SparkFun, USA

The USB Host Shield contains all of the digital logic and analog circuitry necessary to implement a full-speed USB peripheral/host controller with your Arduino. This means you could use your Arduino to interface with and control any USB slave device - thumbdrives, digital cameras, bluetooth dongles, and much more!


A four-wire serial interface is used to communicate with the host controller chip, so the shield connects the Arduino's hardware SPI pins (D10-13) to the MAX3421E. A USB type A female connector is wired up to the IC, and it also supplies 5V as any normal USB port would.

The Host Shield takes its power from the 'Vin' pin on your Arduino. Power from that pin is regulated to both 5V and 3.3V on the shield. All SPI signals are sent through a hex converter to step them down to 3.3V.

Click here to know more.

Documents:

Question & Answer

Total 1 questions

Q: Yo, will this work with 3G modems for Remote Sensing ? Questioned by suntop, 09-Oct-2014

This link has a full list of supported devices which says that it supports mobile phones. As, 3G modems also uses SIM technology, we think it is possible. http://www.circuitsathome.com/arduino_usb_host_shield_projects Here are some clues too. http://forum.arduino.cc/index.php?topic=95699.0 Answered by A.R, 11-Oct-2014 04:43 AM

Thanks for the link ...... I have to check thoroughly on the web to be sure ! Answered by suntop, 12-Oct-2014 19:21 PM

Reviews & Ratings

0 Ratings / 0 Reviews

[0]

[0]

[0]

[0]

[0]

icon

Help: 09678110110

09.00am - 08.00pm (7 days a week)

icon

Pay cash on delivery

Pay cash at your doorstep

icon

Service

All over Bangladesh

icon

Warranty and Replacement

Up to 1 Year